Extruder Line Sheeting

USED LABORATORY WAYNE SHEET EXTRUSION LINE INCLUDING THE FOLLOWING: A) (1) USED 1.75" 30:1 WAYNE EXTRUDER HAVING A 4-ZONE ELECTRICALLY HEATED, AIR COOLED BARREL AND VENTED BARREL. GEARBOX IS DRIVEN BY A 25 HP AC MOTOR WITH INVERTER. INTEGRAL TEMPERATURE PANEL HAS (4) BARREL ZONES, (4) DIE ZONES, AS WELL AS AN EXTRA PANEL WITH (3) ADDITIONAL ZONES. BARREL PRESENTLY HAS A VENT PLUG INSTALLED AND ALSO INCLUDES A VENT STACK WITH VACUUM PUMP MOUNTED ON THE EXTRUDER BASE. 2" CHIVA MANUAL SCREEN INSTALLED ON EXTRUDER DISCHARGE. MANUFACTURED IN 2004. SERIAL #8277. 460 VOLT/3/60. 100 AMPS. WITH SPARE SCREW AND SCREW PUSHER. B) (1) USED CLOEREN MASTERFLEX SHEET DIE HAVING A 10" WIDE SLOT OPENING. UNIT HAS A REMOVABLE LOWER LIP AND A 45 DEGREE RESTRICTOR BAR. FIVE(5) ADJUSTMENT STUDS ON RESTRICTOR BAR. DIE IS A MODEL R2200. JOB #/06-8350. MANUFACTURED IN 2006. INCLUDES STEEL DIE CART. C) (1) USED WAYNE LABORATORY SHEET TAKE-OFF UNIT HAVING THREE (3) 12.5" FACE X NOMINAL 6" DIAMETER CHROME PLATED ROLLS MOUNTED IN A VERTICAL ARRANGEMENT FOR DOWNSTACK OPERATION. TOP AND BOTTOM ROLL ARE AIR ACTUATED WHILE THE MIDDLE ROLL IS STATIONARY. ALL THREE ROLLS ARE DRIVEN BY A 3/4 HP MOTOR THROUGH A GEAR REDUCER. PACKAGE INCLUDES 12.5" WIDE PULL ROLL STAND WITH TWO (2) RUBBER ROLLS DRIVEN BY 1/2 HP MOTOR THROUGH A GEAR REDUCER. TOP ROLL IS AIR ACTUATED. 230/1/60. SERIAL NUMBER 8279. MFD 2004. ALL CONTROLS ARE MOUNTED ON THE PULL ROLL STAND. D) TEMPERATURE CONTROL OF ROLLS IS VIA THREE (3) ADVANTAGE SENTRA MODEL SK10-10352 E2-21D7 WATER TEMP UNITS. MFD 3/21/04. 230 VOLT/3 PHASE/60 CYCLE. 25.5 AMPS PER UNIT. E) TWO (2) WAYNE SINGLE POSITION CANTILIVERED WINDERS WITH CONTROLS.