Wytłaczarki/Ekstrudery - linie do produkcji rur

USED DAVIS STANDARD/CONAIR CO-EXTRUSION PROFILE LINE DESIGNED TO EXTRUDER PVC FENCE. ALL EQUIPMENT WAS MANUFACTURED 2002 AND IS UNDER 500 HOURS OF USE. STILL INSTALLED AS OPERATED. INCLUDED IS THE FOLLOWING: A) DAVIS STANDARD MODEL GP114 TWIN SCREW EXTRUDER HAVING 214MM PARALLEL SCREWS WITH A 28:1 L/D. GEARBOX HAS A RATIO OF 28:1 AND IS DRIVEN BY A 100 HP DC MOTOR WITH SCR CONTROL. STARVE FEEDER MOUNTED ON EXTRUDER FEED SECTION, (6) BARREL ZONES OF EUROTHERM 2208, WITH CONTROLS. B) DAVIS STANDARD MODEL GC61 CONICAL TWIN SCREW EXTRUDER HAVING 61MM CONICAL TWIN SCREW, VACUUM VENTS, GEARBOX DRIVEN BY 40 HP MARATHON AC MOTOR WITH ALLEN BRADLEY CONVERTER. C) 24' VACUUM CALIBRATION TANK CONSISTING OF (1) 4' COMPARTMENT AND (2) 10' COMPARTMENTS. D) (1) USED CONAIR 21' SPRAY TANK HAVING A 16" X 16" CROSS SECTION, MEASURING 21' IN LENGTH, WITH STAINLESS STEEL CONSTRUCTION. E) CONAIR CLEAT TYPE PULLER HAVING 8" WIDE CLEATS WITH NOMINAL 88" OF CONTACT. EACH BELT IS DRIVEN BY A 3 HP AC MOTOR WITH INVERTER. SPEED RANGE 2-20' PER MINUTE. F) CONAIR CUT OFF SAW HAVING AN 8" DIAMETER BLADE X 3 HP MOTOR, 15" OF TABLE TRAVEL GOOD FOR UP TO 6" X 6" WIDE PROFILES, OR 1"" X 13" PROFILES. G) CONAIR 12" WIDE X 16" LONG STAINLESS STEEL DUMP TABLE. UNIT ADJUSTS FROM 39" TO 45" OF LENGTH. PNEUMATICALLY ACTUATED. H) DIES AND CALIBRATORS INCLUDING BUT NOT LIMITED TO THE FOLLOWING: 5" X 5" FENCE POST PROFILE, 2" X 6" FENCE RAIL PROFILE ALSO INCLUDES INJECTION MOLD AND BLOW MOLDS FOR ACCESSORY PARTS.