Extruder Line Sheeting

USED WELEX SHEET EXTRUSION LINE INCLUDING THE FOLLOWING: A) (1) USED 2.5" 30:1 MODEL 2.5 30/1 VRH WELEX EXTRUDER HAVING A 4-ZONE ELECTRICALLY HEATED, AIR AND WATER COOLED, VENTED AND PLUGGED BARREL AT APPROXIMATELY A 46" CENTERLINE HEIGHT. FIRST ZONE OF BARREL IS WATER COOLED VIA CLOSED LOOP SYSTEM, ZONES 2, 3 & 4 ARE AIR COOLED VIA BLOWERS. INTEGRAL PANEL HAS ELEVEN(11) ZONES OF CHROMALOX 1/4 DIN INSTRUMENTS. GEARBOX HAS A RATIO OF 9.3/1 AND IS BELT DRIVEN BY APPROX A 50 HP DC MOTOR WITH QUANTUM II DIGITAL DRIVE. 460/3/60. 225 AMPS. . B) (1) USED 2.5" WELEX HYDRAULIC SLIDE PLATE SCREEN CHANGER HAVING TWO (2) NOMINAL 2.5" DIAMETER BREAKER PLATES. WITH POWER PACK, VAVLE AND HOSES.. C) (1) USED STATIC MIXER WITH VALVED ADAPTER. D) (1) USED 26" H-40 SHEET DIE. DIE LAST USED ON .020 THICK LOW DENSITY POLYETHYLENE. E) (1) USED 35" WELEX MODEL 35X12 SHEET TAKE OFF UNIT CONSISTING OF (3) 35" FACE X NOMINAL 12" DIAMETER ROLLS. MOUNTED IN A VERTICAL ARRANGEMENT AND SET UP FOR DOWNSTACK OPERATION AT APPROXIMATELY A 46" CENTERLINE HEIGHT. TOP AND MIDDLE ROLLS ARE CHROME PLATED WHILE BOTTOM ROLL HAS MATT FINISH. THE ROLLS DRIVEN VIA SILENT CHAIN BY A DC MOTOR THROUGH A GEARBOX. AIR ACTUATED TOP AND BOTTOM ROLL. UNIT HAS 3-ZONE BUILT ONTO FRAME TEMPERATURE SYSTEM WITH PUMPS, HEATERS, HEAT EXCHANGERS AND CONTROLS. ALSO INCLUDED IS 35" WIDE PULL ROLL STAND, IDLER CONVEYOR AND INTEGRAL CONTROL PANEL.. 460/3/60. F) (1) USED WELEX 40" 2 SHAFT FIXED SHEET WINDER. EACH STATION ABLE TO WIND UP TO APPROXIMATELY A 30" O.D. PACKAGE. TORQUE MOTOR ON EACH WINDING STATION WITH RHEOSTAT CONTROL. 460/3/60.