Extruder Line Sheeting

USED KILLION SHEET EXTRUSION LINE CONSISTING OF THE FOLLOWING: A) MODEL KN-150 1.5" 24/1 KILLION EXTRUDER HAVING A 3 ZONE ELECTRICALLY HEATED AIR COOLED TOP VENTED AND PLUGGED BARREL WITH APPROXIMATELY A 42" CENTERLINE HEIGHT. GEARBOX IS BELT DRIVEN BY A 15 HP DC MOTOR WITH EMERSON SCR CONTROL. INTEGRAL TEMPERATURE PANEL HAS 8 ZONES OF EUROTHERM 808 CONTROLLERS, C-CLAMP MOUNTED ON END OF BARREL. S/N 10885N. 460 VOLT, 3 PHASE, 60 CYCLE. GRAVITY FEED HOPPER WITH LID MOUNTED ON FEED THROAT. ALSO INCLUDES SPARE GROOVED FEED THROAT. EXTRUDER MANUFACTURED IN 1988. B) 8" KILLION SHEET DIE HAVING AN ADJUSTABLE UPPER SLIDING LIP AND FIXED REMOVABLE LOWER LIP. C) SHEET STACK HAVING (3) 10" FACE X NOMINAL 5" DIAMETER CHROME PLATED ROLLS, MOUNTED IN A VERTICAL ARRANGEMENT FOR A DOWNSTACK OPERATION AT APPROXIMATELY A 42" CENTERLINE HEIGHT. TEMPERATURE VIA A STERLCO MODEL M8432-4 3 ZONE WATER TEMPERATURE UNIT. EACH ZONE HAS 9KW HEATER, PUMP AND M-2 MICROPROCESSOR CONTROL. STERLCO IS 230 VOLT 3 PHASE, 60 CYCLE, RATED AT 72 AMPS. CHROME ROLLS AND PULL ROLLS ARE EACH DRIVEN BY 3/4 HP DC MOTOR THROUGH GEAR REDUCER. CHROME ROLLS ARE MOUNTED ON SAME FRAME AS COOLING POLISHING STAND. ALSO INCLUDES INTEGRAL CONTROLS. S/N 10885N. D) (1) USED 10" KILLION SINGLE SHAFT WINDER WITH CONTROLS.